Loading ...
Loading ...
Loading ...
Chapter 4. Routing | 265
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Route Redistribution
Use the RIP Route Redistribution page to configure which routes are redistributed to other
routers using RIP. The allowable values for each fields are displayed next to the field. If any
invalid values are entered, an alert message is displayed with the list of all the valid values.
To display the Route Redistribution page, click Routing
RIP Advanced Route
Redistribution.
RIP Route Redistribution Configuration
This screen can be used to configure the RIP Route Redistribution parameters. The
allowable values for each fields are displayed next to the field. If any invalid values are
entered, an alert message will be displayed with the list of all the valid values.
1. The Source select box is a dynamic selector and is populated by only those Source
Routes that have already been configured for redistribute by RIP. Use Source to
configure another Source Route from among the Available Source Routes. The valid
values are:
• Static
• Connected
• OSPF
2. Use Redistribute Mode to enable or disable RIP redistribute mode. The default value is
disable.
3. Use Metric to specify the Metric of redistributed routes for the given Source Route.
4. Use Distribute List to set the Access List that filters the routes to be redistributed by the
destination protocol. Only permitted routes are redistributed. If this command refers to a
non-existent access list, all routes are permitted. The valid values for Access List IDs are 1
to 199. When used for route filtering, the only fields in an access list that get used are:
• Source IP Address and netmask
• Destination IP Address and netmask
• Action (permit or deny)
All other fields (source and destination port, precedence, tos, etc.) are ignored.
Loading ...
Loading ...
Loading ...