Netgear ‎GSM7328FS-200NES - 26-Port SFP/Gigabit Stackable Fully Managed Switch

User Manual - Page 235

For GSM7328FS-200NES. Series: 7000 Series

PDF File Manual, 628 pages, Read Online | Download pdf file

GSM7328FS-200NES photo
Loading ...
Loading ...
Loading ...
Chapter 4. Routing | 235
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
IPv6 Interface Configuration
Use the Interface Configuration page to configure IPv6 interface parameters.
To display the IPv6 Interface Configuration page, click Routing
IPv6 Advanced Interface
Configuration.
1. Use Interface to select the interface to be configured or displayed. All physical
interfaces are valid.
2. Use IPv6 Mode to enable/disable IPv6 mode. When IPv6 mode is enabled, interface is
capable of IPv6 operation without a global address. In this case, an EUI-64 based link-local
address is used. This selector lists the two options for IPv6 mode: enable and disable.
Default value is disable.
3. Use Routing Mode to enable/disable routing mode of an interface. Default value is disable.
4. Use Admin Mode to enable/disable the Administrative Mode of the interface. The default
value is enable. This mode is not supported for Logical VLAN Interfaces.
5. Use MTU to specify the maximum transmit unit on an interface. If the value is 0 then this
interface is not enabled for routing. It is not valid to set this value to 0 if routing is enabled.
Range of MTU is 1280 to 1500.
6. Use Duplicate Address Detection Transmits to specify the number of duplicate address
detections transmits on an interface. DAD transmits values must be in range 0 to 600.
7. Use Life Time Interval to specify the router advertisement lifetime field sent from the
interface. This value must be greater than or equal to the maximum advertisement interval.
0 means do not use the router as the default router. The range of router lifetime is 0 to 9000.
8. Use Adv NS Interval to specify the retransmission time field of router advertisement sent
from the interface. A value of 0 means interval is not specified for router. Range of neighbor
solicit interval is 1000 to 4294967295.
9. Use Adv Reachable Time to specify the router advertisement time to consider neighbor
reachable after ND confirmation. Range of reachable time is 0 to 3600000.
Loading ...
Loading ...
Loading ...