Loading ...
Loading ...
Loading ...
214 | Chapter 4. Routing
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
1. Use Routing Mode to select enable or disable. You must enable routing for the switch
before you can route through any of the interfaces. The default value is disable.
2. Use ICMP Echo Replies to select enable or disable. If it is enable then only the router can
send ECHO replies. By default ICMP Echo Replies are sent for echo requests.
3. Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface
level then only the router can send ICMP Redirects.
4. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number
of ICMP error packets that are allowed per burst interval. By default, Rate limit is 100
packets/sec i.e., burst interval is 1000 msec. To disable ICMP Rate limiting, set this field to
'0'. Valid Rate Interval must be in the range 0 to 2147483647.
5. Use ICMP Rate Limit Burst Size to control the ICMP error packets by specifying the
number of ICMP error packets that are allowed per burst interval. By default, burst size is
100 packets. When burst interval is 0 then configuring this field is not a valid operation. Valid
Burst Size must be in the range 1 to 200.
Table 7.
Field Description
Default Time to Live The default value inserted into the Time-To-Live field
of the IP header of datagrams originated by the
switch, if a TTL value is not supplied by the transport
layer protocol.
Maximum Next Hops The maximum number of hops supported by the
switch. This is a compile-time constant.
Loading ...
Loading ...
Loading ...