Loading ...
Loading ...
Loading ...
258 | Chapter 4. Routing
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
• None - Selected if the user does not want to delete any entry from the ARP Table.
7. Use Remove IP Address to enter the IP Address against the entry that is to be removed
from the ARP Table. This appears only if the user selects Specific Dynamic/Gateway Entry
or Specific Static Entry in the Remove from Table Drop Down List.
Table 23.
Field Description
Total Entry Count Total number of Entries in the ARP table.
Peak Total Entries Highest value reached by Total Entry Count. This
counter value is restarted whenever the ARP table
Cache Size value is changed.
Active Static Entries Total number of Active Static Entries in the ARP
table.
Configured Static Entries Total number of Configured Static Entries in the ARP
table.
Maximum Static Entries Maximum number of Static Entries that can be
defined.
RIP
RIP is an Interior Gateway Protocol (IGP) based on the Bellman-Ford algorithm and targeted
at smaller networks (network diameter no greater than 15 hops). The routing information is
propagated in RIP update packets that are sent out both periodically and in the event of a
network topology change. On receipt of a RIP update, depending on whether the specified
route exists or does not exist in the route table, the router may modify, delete, or add the
route to its route table.
From the RIP link, you can access the following pages:
• Basic on page 258
• Advanced on page 260
Basic
From the Basic link, you can access the following pages:
• RIP Configuration on page 259
Loading ...
Loading ...
Loading ...