Loading ...
Loading ...
Loading ...
Chapter 7. Monitoring the System | 559
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Cable Test
To display the Cable Test page, click Monitoring Ports> Cable Test.
1. Interface - Indicates the interface to which the cable to be tested is connected.
2. Click Apply to perform a cable test on the selected interface. The cable test may take up to
2 seconds to complete. If the port has an active link then the link is not taken down and the
cable status is always “Normal”. The command returns a cable length estimate if this feature
is supported by the PHY for the current link speed. Note that if the link is down and a cable
is attached to a 10/100 Ethernet adapter then the cable status may be “Open” or “Short”
because some Ethernet adapters leave unused wire pairs unterminated or grounded.
Loading ...
Loading ...
Loading ...