Loading ...
Loading ...
Loading ...
Routine Maintenance
Area Method Interval
If cutting continuous,
pressure-sensitive media
Solvent* After every roll of media (or more often,
depending upon your application and media).
Cutter
module
If cutting tag stock or
label liner material
Solvent* and
air blow
After every two or three rolls of media.
Tear-off/peel-off bar Solvent* Once a month.
Take-label sensor Air blow Once every six months.
Table 10Recommended Cleaning Schedule(Continued)
* Zebra recommends using Preventive Maintenance Kit (part number 47362). In place of this kit, you may
use a clean swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water (maximum
10%).
Cleaning the Exterior, the Media Compartment, and the Sensors
Over time, dust, grime, and other debris may build up on the outside and inside of your printer, particularly
in a harsh operating environment.
Printer Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a mild
detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
IMPORTANT:
Zebra is not responsible for damage caused by the use of cleaning fluids on this printer.
Media Compartment and Sensors
To clean the sensors:
1. Brush, air blow, or vacuum any accumulated paper lint and dust away from the media and ribbon paths.
123
Loading ...
Loading ...
Loading ...