Loading ...
Loading ...
Loading ...
Printer Configuration and Adjustment
• SHORT CAL—sets the media and web thresholds without adjusting sensor gain, determines the label
length, and feeds the media to the next web.
See Power-Up Action or Head-Close Action.
Performing Manual Sensor Calibration
IMPORTANT: Follow the calibration procedure exactly as presented. All of the steps must be
performed even if only one of the sensors requires adjustment. You may press and hold CANCEL
at any step in this procedure to cancel the process.
1. With the printer in the Ready state, initiate media and ribbon calibration in one of these ways:
• Press and hold PAUSE + CANCEL for 2 seconds.
• Send the ezpl.manual_calibration SGD command to the printer. See the Zebra Programming Guide
for more information about this command.
• ZT230 printer only:
• Navigate to the following menu item on the control panel display. This item is located under the
TOOLS menu and the SENSORS menu. See Idle Display, Home Menu, and User Menus on page
15 for information about using the control panel and accessing the menus. See the User Guide
for information about using the control panel and accessing the menus.
• Press RIGHT SELECT to select START.
The printer does the following:
• The STATUS light and SUPPLIES light flash yellow once.
• The PAUSE light blinks yellow.
• The control panel (ZT230 printer only) displays:
CAUTION: The printhead may be hot and could cause severe burns. Allow the printhead to
cool.
112
Loading ...
Loading ...
Loading ...