Loading ...
Loading ...
Loading ...
Printer Configuration and Adjustment
Low Tension Setting
To place a spindle in the low-tension position, firmly push in the end cap until it retracts and clicks in place.
Use this setting only when necessary, such as if the ribbon causes scuff marks at the beginning of a roll or
if normal tension causes the ribbon to stall at the end of the roll.
Figure 8Ribbon Spindles— Low Tension Setting (SpindleEndCapsPushedIn)
Removing Used Ribbon
Remove used ribbon from the ribbon take-up spindle each time you change the roll of ribbon.
1. Has the ribbon run out?
If... Then...
Ran out Continue with the next step.
Did not run out a. Cut or break the ribbon before the ribbon take-up spindle.
b. Continue with the next step.
120
Loading ...
Loading ...
Loading ...