Loading ...
Loading ...
Loading ...
15.9.1 To Set the Data Channel Source and the Threshold
Select the Data Channel
Click or tap the drop-down button of Data to select the desired data channel source
(CH1-CH4).
Set the Threshold
Click or tap the input field of Threshold, and then use the pop-up numeric keypad to
set the threshold of the source channel. You can also use the corresponding
multipurpose knob to set the value.
When you modify the threshold of the channel, a dotted line displaying the current
threshold level is displayed on the screen. It disappears in about 2 s after you stop
modifying the threshold.
15.9.2 Display-related Settings
In Decode menu, set the following display-related parameters.
Set the Display Format
Click or tap the drop-down button of Format to select the display format of the bus
data and event table. The available options include "Hex", "Dec", "Bin", and "ASCII".
Set the Label Display
Click or tap the Label on/off switch to enable or disable the label display of the
decoding bus. When enabled, the bus label will be displayed at the upper-left side of
the bus (when the bus display is enabled). The label shows the current bus type.
15.9.3 Event Table
Open or Close the Event Table
Click or tap the Event Table on/off switch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
You can also click or tap the icon at the upper-right corner of the table to close
the event table.
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DHO4000 User Guide
225
Loading ...
Loading ...
Loading ...