Loading ...
Loading ...
Loading ...
One Bit
60%
70%
80%
Figure 15.14 Sample Position
Click or tap the input field of
Sample Position to set it by using the pop-up numeric
keypad. You can also use the corresponding multipurpose knob to set the value. The
settable range is from 10% to 90%.
Set the CAN-FD Baud
CAN-FD baud is a dedicated parameter configured for the CAN-FD decoding. It is
available only when the CAN-FD option is installed. Click or tap the drop-down
button of CAN-FD Baud to select the variable baud rate. The available baud rates
include 1 Mbps, 2 Mbps, 3 Mbps, 4 Mbps, and etc.
Set the FD Sample Position
FD sample position is a dedicated parameter configured for the CAN-FD decoding. It
is available only when the CAN-FD option is installed. Click or tap the input field of FD
Sample Position to set it by using the pop-up numeric keypad. You can also use the
corresponding multipurpose knob to set the value. The settable range is from 10% to
90%.
15.5.2 Display-related Settings
In Decode menu, set the following display-related parameters.
Set the Display Format
Click or tap the drop-down button of Format to select the display format of the bus
data and event table. The available options include "Hex", "Dec", "Bin", and "ASCII".
Set the Label Display
Click or tap the Label on/off switch to enable or disable the label display of the
decoding bus. When enabled, the bus label will be displayed at the upper-left side of
the bus (when the bus display is enabled). The label shows the current bus type.
15.5.3 Event Table
Open or Close the Event Table
Click or tap the
Event Table on/off switch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
Protocol Decoding
DHO4000 User Guide
212
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...