Loading ...
Loading ...
Loading ...
67 SHS800 Series
Appendix B: Battery Installation
The battery of the SHS800 is separated from it’s host, please install the battery
according to following steps:
1. Dismantle the two screws of the battery cap by using screw knife, as figure 1 shows..
2. Draw back the packing block of the Handheld Digital Oscilloscope, and then
dismantle the battery cap, as figure 2 shows.
3. Put battery into the battery bin stably, as figure 3 shows.
4. Cover the battery cap, and tightly twist the two screws which are dismantled from the
battery cap forward, such as figure 3 shows.
5. Successful installation of the battery depends on whether the Handheld Digital
Oscilloscope could be normally turned on or not.
Notes:
The battery plug is designed to prevent from connecting reversely, it prefers
operating slightly to powerfully.
Make a caution at the direction of the battery cap, logo of the battery is attached to
the external end.
If The Handheld Digital Oscilloscope can not be turned on normally after correctly
installation, it is likely that the battery quantity of electricity has been used off, please
refresh for the battery right away.
In the case of not working, battery must be charged once every three months.
Figure 1 Figure 2
Figure 3
Loading ...