Loading ...
Loading ...
Loading ...
Sears Recommends
the Following Accessories ............................
Sears Recommends the Following Accessories
Item Cat. No.
Caster Sets .................................................. See Catalog
7 in. Molding Head Set ................................ See Catalog
7 In. Molding head ....................................... See Catalog
8 In. Molding Head ...................................... See Catalog
Molding/Dado Insert for 7 In. Dia. Molding
or Dado Head ..................................................... 9-29997
Molding/Dado Insert for 8 IN. Dia. Molding
or Dado Head ..................................................... 9-22287
Work Light ................................................... See Catalog
8 in. & 7 In. Dia Adjustable Dado Head ...... See Catalog
7 In. Dia. Dado Head ................................... See Catalog
Sanding Wheel ............................................ See Catalog
Sawdust Collector .............................................. 9-29962
Whole Shop Sawdust Collector Kit ..................... 9-29964
Replacement Handwheels ................................. 9-22260
Cast Iron Extensions .......................................... 9-22261
Storage Hooks (Miter Gauge/Rip Fence) ........... 9-32038
Item Cat. No.
Miter Gauge ....................................................... 9-29930
Miter Gauge Stop Rods ...................................... 9-29924
Miter Gauge Hold-Down Clam p ......................... 9-29928
Taper Jig ..................................................... See Catalog
Universal Jig ................................................ See Catalog
Power Tool Know How Handbook ..................... 9-29114
Exacti-R ip-Fence ............................................... 9-29901
XR-2424 Rip Fence ............................................ 9-29902
Sears may recommend other accessories not listed in
manual.
See your nearest Sears store for other accessories.
Do not use any accessory unless you have received and
read complete instructions for its use.
I WARNING: Use only accessories recommended for I
this saw. Using other accessories may be danger-
ous,
Troubleshooting ..............................................
__ARN_NG: F__ y_ur _wn ___t_cti_n_ turn switch ``_FF__and a_way_ _em_ve p_ug fr_m powe_ s_u_ce _ut_et _beforetroubleshooting.
General
Probable Cause Remedy
Excessive Vibration 1. Blade out of balance 1. Discard blade and use a different blade.
2. Belt damaged 2. Replace V-Belt.
Cannot make square 1. Miter gauge not adjusted prop- 1. See "Adjustments" section "Miter Gauge."
cut when crosscutting, erly.
1. Dull blade or improper tooth set.
Cut binds, bums or
stalls motor when rip- 2. Blade is heeling.
ping. !3. Warped board
Tilt and elevating hand-
4. Rip fence not parallel to blade.
5. Spreader out of alignment.
1. Sawdust on threads of tilt screw
1. Sharpen or replace blade.
2. See "Adjustments" section, "Heeling Adjustment".
3. Make sure concave or hollow side is facing "down"
feed slowly.
4. See "Assembly" section, "Aligning Rip Fence."
5. See "Assembly" section, "Installing Blade Guard."
1. See "Adjustment" section, "Blade Tilt, or Squareness
of Blade to Table".
1. See "Maintenance" and "Lubrication" sections.
2. See "Maintenance" section, 'Tilt and Elevation
Mechanism"
48
Loading ...
Loading ...
Loading ...