Loading ...
Loading ...
Loading ...
Adjustments (continued) - -
A,lf blade is square to table
1 Check pointer, if pointer does not point to the "0"
mark on the bevel scale, the pointer must be
adjusted.
a. Remove elevation handwheel.
b Loosen screw and adjust pointer using medium
screwdriver.
c. install elevation handwheel.
B.lf blade is not square to table, the 90 ° stop screw
must be adjusted.
1. Unscrew 90 ° stop screw three to four turns using
3/16 inch hex "L" wrench
2. Turn tilt handwheel clockwise one turn. then turn
handwheel counterclockwise until blade is square
with table.
3_ Screw 90 ° stop screw in until it stops. Check once
again for squareness and readjust screw, if nec-
essary.
4o Check pointer as described in step A above.
Pointer at
0 ° Position
Pointer"
Adjusting Screw
Scale Adjusting
Screw
Q
90 °
Stopscrew
To check for alignment, 45 ° Position
Tilt blade to left as far as it will go.
1. Place an accurate square against blade. Make sure
square is not touchingthe tip of one of the saw teeth.
A.If blade is 45° to table;
1. Check pointer. If pointer does not point to the 45°
mark on the scale, the scale must be adjusted.
2. Remove elevation handwheel.
3. Loosen two screws on scale and adjust scale until
pointer pointsto 45° mark.
4. Install elevation handwheel.
\
B.If blade is not 45 ° to table, stop screw and scale
must be adjusted.
1. Unscrew 45 ° stop screw three to four turns using
3/16 inch setscrew wrench.
2. Turn tilt handwheel until blade is 45 ° to the table.
3. Screw 45 ° stop screw in until it stops. Check once
again and readjust screw, if necessary.
4. Check pointer as described in step A above.
46
Scale Screws
45°
Stopscrew
Loading ...
Loading ...
Loading ...