Loading ...
Loading ...
Loading ...
Motor Connections
WARNING: For your own safety, never connect I
plug to power source outlet until all assembly
!
steps are completed.
1. Open motor connector box cover located on side of
motor using a flat blade screwdriver.
j WARNING: To avoid electrocution, never connect
anything but the ground wire (colored green) to
the green screw.
2. Remove green screw and insert through round metal
terminal on the end of the green wire of motor cord.
3, Reinsert green screw in threaded hole that it was
removed from and tighten securely.
4. Connect terminal end of black wire to terminal #1 on
the motor. Push terminal firmly until seated.
5. Connect terminal end of white wire to terminal #4 on
the motor. Push terminal firmly until seated,
6. Close motor connector box being sure that motor
cord is seated in lower strain relief groove and
tighten box cover screws.
7. Do not plug in power cable.
Black Motor
Cord Lead On
nal #1
Green Motor
Cord Lead
Under Green
"ew
Cord in
Strain Relief
Groove
\White M otor
Cord Lead On
Terminal #4
Motor Cord Connections
8. From the bag labeled "Large Parts" find the following:
2 Wire Ties
9. Route motor cord and power cord along right side of
cabinet. Use a hammer to lightly tap the pointed tabs
on the wire ties into the holes provided on side of
cabinet. Secure both cords in wire ties.
10. Plug motor cord into outlet on side of switch box.
NOTE: This completes the assembly of your table saw.
Do not throw away any remaining hardware until you
have read the entire owners manual.
Wire Tie
Wire Tie
Two Cords
\
Cabinet
Wire
Tie
27
Loading ...
Loading ...
Loading ...