Loading ...
Loading ...
Loading ...
instaW_ing Rear Fence Guide Bar
1. F_om the bag labeled "Guide Bars" remove only the
following hardware:
_5 Square Head Bolts, 5/16-18 x 1" Long
*5 Lockwashers, 5/16 External Type
*5 Flat Washers, 21/64 x 5/8 x 1/16
*5 Hex Nuts, 5/16-18
From among the Joose parts find the following:
1 Rear Guide Bar 40-3/4" long
Items marked with an asterisk (*) are shown actual
size.
2. Insert five 5/16-18 x 1" long square head bolts into the
holes as shown.
3. Attach flat washer, Dckwasher and hex nut loosely, as
shown, so the bolt head protrudes through the rear
edge of the table and extensions.
G
5/16 in. External
Lockwasher
21164 I.D.
Flat Washer
5/16-18
Hex Nut
4. Slide the rear guide bar slot over each of the square
head bolts, similar to the front guide bar assembly.
5. Center the rear guide bar using a framing square or
straight edge positioned against the right side of the
blade (looking at front of saw). This should align the
mark on the rear guide bar to the same blade side of
blade as on front rail.
6. Push rear guide bar against the saw table and exten-
sions. Finger tighten each nut on the table and exten-
sions. The guide bars will be aligned and the nuts
tightened at a later time. This procedure will be
checked and probably reset during later bar align-
ments.
7. Shims may be required between the rear guide bar
and saw table or extensions. See instructions for
adjusting rip fence guide bars.
WARNING: Front and rear guide bars must be
aligned with blade. Misaligned guide bars could
twist. Twisted guide bars could misalign fence. A
misaligned fence could cause binding or kickback.
You could be hit or cut.
Hex
/
Flat
Washer
!
(
Square Head
Bolt
Rear of Table or
Rear Extension \
Guide Bar\ \._
\
Square Head
Boff
i
I
i
i
Mark on
Rear g_de bar
|, ,':
i
i
!
1
I
I
i
_Straight Edge
ยข
/
/
Front of Saw
' I
17
Loading ...
Loading ...
Loading ...