Loading ...
Loading ...
Loading ...
Work Feed Devices (continued) ............
Making the handle:
• Miter crosscut a piece of 3/4 inch thick plywood to
shape and size shown:
NOTE: The mitered corners can be any size that looks
likethe drawing (about 1-1/2" by 1-1/2").
Putting it Together
• Using good quality woodworking glue, glue the 3/8" x
3/8" x 2:1/2" piece strip saved earlier to the base as
shown.
IMPORTANT: Do not use nails or screws. This is to pre-
vent dulling of the sawblade in the event you cut into the
push block.
• Position the handle at the center of the plywood base
as shown. Fasten them together with glue and wood
screws.
IMPORTANT: Make sure the screw heads do not stick
out fmrn the bottom of the base, they must be flush or
recessed. The bottom must be flat and smooth enough to
slide along the auxiliary fence you are now ready to
make.
314"Plywood Handle
Finished Push Block
J
1-1/2"
1-
'_2" =--
Glue Only
J
L__I
/ i
Screw Head Must Be
Flush Or Recessed
5"
Cutting Out the Base
A
Auxiliary Fence |-- 30"
--i---,-J
Making the base: 2-5/8-
Ar
"Start with a piece of 3/8 inch plywood at least 5-1/2 3-1_'|
inches wide or wider and 30 inches long or longer.
• Cut the piece to shape and size shown:
Making the side:
Cutting Out the Side
• Start with a piece of 3/4 inch plywood at least 2-3/8
inches wide or wider and 27 inches long or longer, i_ 27"
• Cut the piece to shape and size shown:
Putting it together:
-Put the pieces together, as shown:
IMPORTANT: Make sure the screw heads do not stick
out from the bottom of the base, they must be flush or
recessed. The bottom must be flat and smooth enough to
rest on the saw table without rocking.
1
34
3/8" Thick Plywood Base
3/4" Thick Plywood Side
Finished Auxiliary Fence
This Face and
This Edge Must
Be Parallel
4-314'
Plywood
2-3/8"
A
1-1/4"
Loading ...
Loading ...
Loading ...