Craftsman 113299315 10" belt drive table saw

Owner's Manual - Page 12

For 113299315.

PDF File Manual, 60 pages, Read Online | Download pdf file

113299315 photo
Loading ...
Loading ...
Loading ...
Assembly
installing Handwheeis
1. From the bag labeled "Miscellaneous" remove only the
10-32 x 5/8
following hardware: Pan Head Screw
*2 Pan Head Screws. 10 - 32 x 5/8" long
"2 Lockwashers. #10 External Type
From among the loose parts find the following:
2 Handwheels
Items marked with astedsk (*) are shown actual size.
2 Line up flat spots on shaft and handwheel, push
handwheel onto shaft. Install screw and Iockwasher to
lock handwheei on shaft. Repeat for the other hand-
wheel.
#10 External
Lockwasher
Elevation
Handwhee!
Tilt
Handwheel
Pan Head
Screw
Handwheel
Assembling Steel Legs
1. From the bag labeled "Legs" remove the following
hardware:
*24 Truss Head Screws. 1/4-20 x 1/2" long
*24 Lockwashers. 1/4" Extemal Type
"24 Hex Nuts, 1/4-20
"8 Hex Nuts, 3/8-16
4 Leveling Feet
From among the loose parts find the following:
4 Legs
2 End Stiffeners
2 Side Stiffeners
4 Leg Stiffeners (Two Short. Two Long)
Items marked with asterisk (*) are shown actual size.
2. Assemble the legs as shown.
Insert the truss head screws through the holes in the
legs. then through the holes in the side arid end stiffen-
ers,
Legs must be assembled on top of stiffeners
3. Install the tockwashers. Screw on the nuts hand tight.
4. Insert the truss head screws through the holes in the
legs, then through the holes in the leg stiffeners.
5 Install the lockwashers. Screw on the nuts but do not
tighten until completely assembled.
6_ Install leveling feet. Through holes in bottom of legs as
showR ;
7. Adjust leveling feet as follows:
a. Move saw to desired location.
b. With 9/16" wrench loosen bottom nut.
c. Back off top nut by hand.
d. Raise or lower foot by adjusting bottom nut using
9/16" wrench_
e. Snug top nut against inside of leg by hand.
!. Tighten atltour bottom nuts using 9/16" wrench.
1/4 In. External
114-20 x 112 In. Lockwasher
Truss Head Screw
Q
318-16 Hex Nut
End
Stiffener
©
1/4-20
Hex Nut
0
Leveling Foot I
(Short) _ Leg
(Long)
Leg Stiffeners Stiffener
i
Side Stiffeners _ Stiffeners
I Legs
114-2o I !1 _ti ,_ i.,.,=..li \\ 'i
Lockwa_/ /'_- _ -_t! ". LegS_ffeners
,..:..r../ il , oo0> |
Leg Stiffeners| I'F \ ............
-(Short) _/i318-16 Hex NlXls
Leveling Foot ---'-_
12
Loading ...
Loading ...
Loading ...