Loading ...
Loading ...
Loading ...
Checking TabBe Rnsert
l WARNBNG: To avoid injury from accidental start, t
make ,sure switch is "OFF" and plug is not con- }
nected to power source outlet.
1. Insert should be flush with tabie top, Check as shown.
Loosen flat head screw that holds insert and adjust the
four set screws as necessary, Tighten fiat head screw,
Do not tighten screw to the point where it bends the
insert,
CAUTION: insert must be even with the tabBe sur-
face. Unserts too high or tow can let the workpiece
"snag" or catch on uneven edges. Workpiece
could twist and kickback,
3/32 in.
Hex "L" Wrench
/
Set Screws
2, To remove insert,
a. Make sure saw is off and unplugged,
b, Loosen fiat head screw,
c. Lift insert from front end, and pull toward front of saw_
3, To repUaee insert.
a. Make sure saw is off and unpk_gged.
b. Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert wil! drop over flat head screw,
Tighten screw,
c. Do not tighten screw to the point where it bends the
insert.
Fiat Head
Screw
J
15
Loading ...
Loading ...
Loading ...