Loading ...
Loading ...
Loading ...
Assembly (continued)
Assernbiing Table Extensions
1. From the bag labeled "Table Extensions" remove the
following hardware: (Quantity indicated is for two
extensions/
"8 Hex Head Screws, 5/16-18 x 1-1/4" Long
*8 Flat Washers, 11/32x 11/16x 1/16
*8 Lockwashers, 5/16" ExternalType
"8 Hex Nuts, 5/16-18
items marked with asterisk (*) are shown actual size.
NOTE: Assemble with saw upside down.
WARNING: Stock table extensions must be
installed. They help support the fence guide bars,
An unsupported guide bar can twist. Twisted
guide bars can misalign fence. A rnisaligned fence
can cause binding or kickback. You could be hit or
cut.
5/16-18 x 1-114 in
Hex Head Screw
5116-18
Hex Nut
5/16 in ExternaJ
Lockwasher 11132i.D.
Fiat Washer
/
2. Insert four (4) 5/16-18 x 1-1/4 in. long screws through
the holes in each extension.
3. Position extension against table so screws extend
through hole in table.
4. Install flat washers, Iockwasher, and nuts on the
screws. With a 1/2" wrench, snug the four nuts just
enough to take the play out between the table and
extension. Do not tighten.
5. Repeat steps 1-4 to installthe other extension.
6. Stand saw upright on legs. Roll saw over onto front
then up onto feet.
-WARNING: The saw is heavy. To avoid back injury,
get help to lift the saw. Hold the saw close to your
body. Bend your knees so you can lift with your
legs, not your back.
7. Line up the front edge of extension with the front edge
of the table. Pull up on front and rear of sheet metal
side extension so it is higher than table. Using a block
of wood and hammer as shown, tap the extension
down until it is even with table top. Recheck alignment
of front edge of table and extension. Tighten front and
rear extension mounting nutsonly,
WARNING: Table extensions must be installed.
Front edge of table and extensions must be lined
bar. Twisted guide bars can misalign fence. A mis-
aligned fence can cause binding or kickback. You
could be hit or cut.
8. Using the block of wood, check to see if center exten-
sion is flush with table top. If adjustment is needed,
push the table top into alignment and tighten center
two mounting nuts.
9. Repeat steps 7 and 8 to align the other extension.
<..
Flat
Washer
Lockwasher
Hex Screw
Line Up Front Of
Table and Extension
14
Loading ...
Loading ...
Loading ...