Loading ...
Loading ...
Loading ...
Getting to Know Your Table Saw
6 Miter Gauge 9 Sawblade 7 Blade Guard
\ \ \
Rip Fence
10
8 Table insert
J
2 Elevation
Wheel
1 On-Off
Switch
1. On-Off Switch.
i CAUTION: turning switch "ON", make sure
Before
the blade guard is correctly instalUed and operat-
ing properly.
The On_Off Switch has a locking feature. This feature is
intended to help prevent unauthorized and possible haz-
ardous use by children and others.
A.To turn saw ON, stand to either sidle of the blade.
never in line with it, insert finger under switch lever
and pull end of lever out.
After turning switch ON. always allow the blade to
come up to full speed before cutting. Do not cycle
the motor switch on and off rapidly, as this may
cause the sawblade to loosen, in the event this
should ever occur, allow the sawb|ade to come to a
complete stop and retighten the arbor nut norrnalty.
not excessively. Never leave the saw while the
power is "ON".
B. To turn saw OFF, PUSH lever in. Never leave the
saw until the cutting tool has corne to a complete
stop.
C.To lock switch in OFF position, hold switch IN with
one hand, REMOVE key with other hand
WARNING: For your own safety, tower blade or
other cutting tool below table surface. (if b|ade is
tired, return it to vertical, 90 °, position.) Always
lock the switch "OFF". When saw' is not in use,
remove key and keep it in a safe p!_ace. Also, in the
event of a power failure (all of your lights go out)
turn switch off, lock it and remove the key. This
will prevent the saw from starting up again when
the power comes back on.
28
PULL O_
Key
(_ pULL 0N I1
PUSH OFF
Loading ...
Loading ...
Loading ...