Loading ...
Loading ...
Loading ...
8. Remove the table insert and lower the blade com-
pletely. The front and rear trunnion can be accessed
for adjustments through the insert opening.
9. Using a wood block and hammer, as shown, move
rear trunnion to right or left as required to realign the
blade, If necessary, shift front trunnion in similar man-
ner, but do not move front trunnion unless necessary,
Raise blade and recheck the alignment with the
square, then securely retighten all six trunnion screws.
Replace insert.
Hammer
- - ..................................................... ,: := ......... i ....,
Blade Tilt, or Squareness of Bnade to Tabne
When the bevel pointer is pointing directly to the "0" mark
on the bevel scale, the sawblade should make a square
cut 90° to the table.
WARNING: For your own safety, turn switch "OFF"
and remove pmugfrom power source outlet.
To check for squareness, 90° position.
1. Raise blade all the way up, raise blade guard.
2. Operate the tilt lock handle (counterclockwise) to
loosen the tilt clamp screw.
NOTE: Handle is spring loaded for engagement with
screw head - must be pushed inward for disengage-
ment whenever necessary to obtain a new grip on
screw head.
3. Rotate tilt handwheel clockwise a few turns to tilt
blade. Now, rotate handwheel counterclockwise until it
stops. Blade should now be square with table and
pointer should point to "0".
Tilt Lock
Handle
Ievei
F ] Pointer
4. Place the square against blade. Make sure square is
not touching the tip of one of the saw teeth.
Blade
Guard /
Square
45
Loading ...
Loading ...
Loading ...