Loading ...
Loading ...
Loading ...
Assembly (continued)
Installing Belt Guard
1. From the bag labeled "Motor_GuardoBase"remove
the following Itardware:
*4 He× Nuts, 10-32
*8 Fiat Washers, 13/64 x 3/8 x 1/32.
From among the loose parts find the following:
1 Belt Guard
Items marked with an asterisk (*) are shown actual
size.
Flat Washer
13164 i.D.
@
10-32 Hex Nut
Press Down on Tab
Lock To Open
Belt Guard
2. Lower blade all the way down and remove the motor
belt.
3. Instal| one flat washer onto each of the four motor
studs.
4. Open the hinged belt guard by pressing down on the
tab lock as shown.
5. Position the guard so the large hole fits around the
pulley. Insert the motor studs through the four small
holes as shown.
6. Attach another washer and one nut to each motor
stud as shown and tighten securely.
7. Reposition the belt on the rnotorand arbor pulley.
8. Close the hinged cover securely until the tab snaps
and locks the cover closed.
9. Check the beff clearances on the guard by raising the
blade to full height using the elevation handwheel.
10. Check motor clearances by rotating the bevel hand-
wheel located on the right side until the indicator is
set at 45°.
Motor-
Stud
Washer
Belt
Guard
Fiat /
Washer
Hex Nut
26
Loading ...
Loading ...
Loading ...