Loading ...
Loading ...
Loading ...
92 GETTING TO KNOW YOUR VEHICLE
3. Continue to press and hold the HomeLink®
button, while you press and release
(“cycle”) your hand-held transmitter every
two seconds until HomeLink® has success
-
fully accepted the frequency signal. The
ind
icator light will flash slowly and then
rapidly when fully trained.
4. Watch for the HomeLink® indicator to
ch
ange flash rates. When it changes, it is
programmed. It may take up to 30 seconds
or longer in rare cases. The garage door
may open and close while you are
programming.
5. Press and hold the programmed
Ho
meLink® button and observe the
indicator light.
NOTE:
If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink® button is pressed.
To program the two remaining Home-
Link® buttons, repeat each step for each
rem
aining button. DO NOT erase the
channels.
If you unplugged the garage door opener/
dev
ice for programming, plug it back in at this
time.
Reprogramming A Single HomeLink® Button
(Ca
nadian/Gate Operator)
To reprogram a channel that has been
pre
viously trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2.
Press and hold the desired HomeLink®
bu
tton until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
“C
anadian/Gate Operator Programming”
step 2 and follow all remaining steps.
Using HomeLink®
To operate, push and release the programmed
HomeLink® button. Activation will now occur for
the programmed device (i.e. garage door
opener, gate operator, security system, entry
door lock, home/office lighting, etc.). The
hand-held transmitter of the device may also be
used at any time.
Security
It is advised to erase all channels before you sell
or turn in your vehicle.
To do this, push and hold the two outside
but
tons for 20 seconds until the orange
indicator flashes. Note that all channels will be
erased. Individual channels cannot be erased.
The HomeLink® Universal Transceiver is
dis
abled when the Vehicle Security Alarm is
active.
NOTE:
The universal garage door opener only operates
whe
n the engine is running for security reasons
associated with removable tops and doors.
Troubleshooting Tips
If you are having trouble programming
HomeLink®, here are some of the most
common solutions:
Replace the battery in the garage door
opener hand-held transmitter.
Push the LEARN button on the garage door
opener to complete the training for a Rolling
Code.
Loading ...
Loading ...
Loading ...