Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 65
NOTE:
Ensure the wire harness is not tucked under the
bel
t rail or between the belt rail and the door
rail.
Incorrect Placement Of Wire Harness
6. I
nstall the door frames. Start with both front
do
ors, followed by both rear doors. Refer to
“Door Frame Installation” in this section for
instructions and appropriate torque specifi
-
cations for the door frame Torx head
fas
teners.
7. Unsnap and remove the storage bag. This
ba
g should be discarded. It was intended as
a protective cover for shipping only.
8. Ensure the top is secured with the provided
ho
ok-and-loop fasteners, then lift the soft
top onto the rear of the cab. Line up the
locater pins (one on each side of the soft
top) with the rear door frames.
9. Using the provided #T50 T
orx head driver
and ratchet, install and tighten the Torx
fasteners by turning them clockwise.
Secure them until they are snug, being
careful not to cross-thread the fasteners or
overtighten. Refer to the following table for
recommended torque specifications.
Repeat on the opposite side.
Step Seven
Soft Top In Place
CAUTION!
Failure to follow the next steps could result in
damage to the soft top or vehicle.
Torque
Specification
For Torx
Fasteners
Maximum Minimum
119.5 in-lbs 150.5 in-lbs 106.2 in-lbs
13.5 N·m 17.0 N·m 12.0 N·m
CAUTION!
Do not overtighten Torx fasteners. You can
strip the fasteners if they are overtightened.
2
Loading ...
Loading ...
Loading ...