Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 69
4. Unfold the outer flap and zip the Freedom
Top bag closed.
Storage Bag Closed
5. Store the Freedom Top bag in a safe loca-
ti
on.
Front Panel(s) Installation
1. Set the right side panel on the windshield
frame with the locating pin in the front
receiver mounting hole, followed by the left
side panel, making sure there is no over
-
hang. Make sure that the panels are sitting
flu
sh with the body.
2. Secure the panel(s) using the same steps
fo
r removal in reverse order.
NOTE:
To prevent water leaks, the seals and Freedom
T
op
Panels should be clear of any dust and
debris prior to reinstallation.
Rear Hard Top Removal
1. Remove both front panels. Refer to “Front
Panel(s) Removal” in this section.
2. Open both front doors.
3.
Using the provided #T50 T
orx head driver
and ratchet, remove the two Torx head
fasteners that secure the hard top at the
B-pillar (near the top of the front doors) on
each side.
Torx Head Fastener Location — Left Side Shown
4. If equipped, remove the rear lower interior
so
ft trim panel attached by a hook-and-loop
fastener.
Interior Soft Trim Panel (If Equipped)
5. R
emove the two Torx head fasteners that
se
cure the hard top to the vehicle (along the
interior bodyside rearward of the back
doors) using the #T50
Torx head driver.
2
Loading ...
Loading ...
Loading ...