Loading ...
Loading ...
Loading ...
90 GETTING TO KNOW YOUR VEHICLE
NOTE:
It is NOT the button that is normally used to
ope
n and close the door. The name and color of
the button may vary by manufacturer.
Training The Garage Door Opener
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to
3 i
nches (3 to 8 cm) away from the Home-
Link® button you wish to program while
k
ee
ping the HomeLink® indicator light in
view.
3. Push and hold the HomeLink® button you
wa
nt to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe
th
e indicator light. The HomeLink® indi-
cator will flash slowly and then rapidly after
H
om
eLink® has received the frequency
signal from the hand-held transmitter.
Release both buttons after the indicator
light changes from slow to rapid.
5. At the garage door opener motor (in the
ga
rage), locate the “LEARN” or “TRAIN”
button. This can usually be found where the
hanging antenna wire is attached to the
garage door opener/device motor. Firmly
push and release the “LEARN” or “TRAIN”
button. On some garage door openers/
devices there may be a light that blinks
when the garage door opener/device is in
the LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
nex
t step after the LEARN button has been
pushed.
6. Return to the vehicle and push the
pr
ogrammed HomeLink® button twice
(holding the button for two seconds each
time). If the garage door opener/device acti
-
vates, programming is complete.
NOTE:
If the garage door opener/device does not acti-
vate, push the button a third time (for two
s
ec
onds) to complete the training.
To program the remaining two HomeLink®
but
tons, repeat each step for each remain-
ing button. DO NOT erase the channels.
Reprogramming A Single HomeLink® Button
(
Ro
lling Code)
To reprogram a channel that has been
pre
viously trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2.
Push and hold the desired HomeLink®
bu
tton until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button proceed with
“P
rogramming A Rolling Code” step 2 and
follow all remaining steps."
1 — Door Opener
2 — Training Button
Loading ...
Loading ...
Loading ...