Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 197
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine, and
permits quicker starts in cold weather. Connect
the cord to a standard 110-115 Volt AC
electrical outlet with a grounded, three-wire
extension cord.
The engine block heater must be plugged in at
lea
st one hour to have an adequate warming
effect on the engine.
The engine block heater cord is found under the
hoo
d bundled in front of the battery tray.
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the
engine and drivetrain (transmission and axle) in
your vehicle.
Drive moderately during the first 300 miles
(50
0 km). After the initial 60 miles (100 km),
spe
eds up to 50 or 55 mph (80 or 90 km/h) are
des
irable.
While cruising, brief full-throttle acceleration
wit
hin the limits of local traffic laws contributes
to a good break-in. Wide-open throttle
acceleration in low gear can be detrimental and
should be avoided.
The engine oil installed in the engine at the
fac
tory is a high-quality energy conserving type
lubricant. Oil changes should be consistent with
anticipated climate conditions under which
vehicle operations will occur.
For the recommended viscosity and quality
gra
des, refer to “Fluids And Lubricants” in
“Technical Specifications”.
NOTE:
A new engine may consume some oil during its
fir
st few thousand miles (kilometers) of opera-
tion. This should be considered a normal part of
t
he
break-in and not interpreted as a problem.
WARNING!
Remember to disconnect the engine block
heater cord before driving. Damage to the
110-115 Volt AC electrical cord could cause
electrocution.
CAUTION!
Never use Non-Detergent Oil or Straight
Mineral Oil in the engine or damage may
result.
5
Loading ...
Loading ...
Loading ...