Loading ...
Loading ...
Loading ...
280 IN CASE OF EMERGENCY
3. Remove and replace LED front side marker
light assembly.
Halogen Front Fog Lamp
NOTE:
We advise referring to an authorized dealer for
ser
vice.
1. Reach under the vehicle to access the
ba
ck of the front fog lamp.
2. Disconnect the wire harness connector
fr
om the front fog lamp connector recep-
tacle.
3. F
irmly grasp the bulb by the two latch
fe
atures and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
op
ening in the housing and then connect
the replacement bulb.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps
the
y are replaced as an assembly.
Rear Tail, Stop, Turn Signal, And Backup
Lamp
1. Remove the two screws that pass through
the bed sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward,
fa
r enough to unsnap the two receptacles
on the outboard side of the lamp housing,
from the two plastic snap post retainers in
the outer box side panel.
3. Remove the screws from assembly bracket
to
access the three bulb sockets.
Assembly Bracket
4. Rotate the appropriate socket a quarter
tu
rn counterclockwise, then remove it from
the housing.
5. Pull the bulb straight from the socket to
re
place.
Center High Mounted Stop Lamp (CHMSL)
The stop lamp is mounted on the tailgate. If
service is needed, obtain the LED assembly
from an authorized dealer.
License Plate Lamps
See an authorized dealer to replace these LED
assemblies.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
Loading ...
Loading ...
Loading ...