Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 91
Programming A Non-Rolling Code
For programming garage door openers
manufactured before 1995.
1. Place the ignition in the ON/RUN position.
2.
Place the hand-held transmitter 1 to
3 i
nches (3 to 8 cm) away from the Home-
Link® button you wish to program while
k
ee
ping the HomeLink® indicator light in
view.
3. Press and hold the HomeLink® button you
wa
nt to program while you press and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe
th
e indicator light. The HomeLink® indi-
cator will flash slowly and then rapidly after
H
om
eLink® has received the frequency
signal from the hand-held transmitter.
Release both buttons after the indicator
light changes from slow to rapid.
5. Press and hold the programmed
Ho
meLink® button and observe the
indicator light.
NOTE:
If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink® button is pressed.
To program the two remaining
HomeLink® buttons, repeat each step
for each remaining button. DO NOT erase
the channels.
Reprogramming A Single HomeLink® Button
(No
n-Rolling Code)
To reprogram a channel that has been
pre
viously trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2.
Press and hold the desired HomeLink®
bu
tton until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
“P
rogramming A Non-Rolling Code” step 2
and follow all remaining steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/
United States that require the transmitter
signals to “time-out” after several seconds of
transmission.
Canadian radio frequency laws require
tra
nsmitter signals to time-out (or quit) after
several seconds of transmission – which may
not be long enough for HomeLink® to pick up
the signal during programming. Similar to this
Canadian law, some U.S. gate operators are
designed to time-out in the same manner.
It may be helpful to unplug the device during the
cyc
ling process to prevent possible overheating
of the garage door or gate motor.
1. Place the ignition in the ON/RUN position.
2.
Place the hand-held transmitter 1 to
3 i
nches (3 to 8 cm) away from the
Hom
eLink® button you wish to program
while keeping the HomeLink® indicator
light in view.
2
Loading ...
Loading ...
Loading ...