Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 13
2. Remove the depleted battery by inserting a
small flat-blade screwdriver into the battery
removal slot and sliding the battery forward
and upward being careful not to damage
the electronic board underneath.
Battery Replacement
3. Install the new battery into the key fob,
ma
king sure the positive (+) side is facing
up. Slide the battery until it is seated
securely below the tabs.
4. Reassemble the back cover making sure it
is
properly aligned before snapping it back
in place.
Programming Additional Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
c
an
not be repurposed and reprogrammed to
another vehicle.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
veh
icle electronics can be used to start and
operate the vehicle. Once a key fob is
programmed to a vehicle, it cannot be
programmed to any other vehicle.
Duplication of key fobs may be performed at an
aut
horized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with
you to an authorized dealer.
Keys must be ordered to the correct key cut
to match the vehicle locks.
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rul
es and with Innovation, Science and
Economic Development Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
en
ce, and
2. This device must accept any interference
re
ceived, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d`I
nnovation, Science and Economic
Development applicables aux appareils radio
WARNING!
Always remove the key fobs from the
vehicle and lock all doors when leaving the
vehicle unattended.
Always remember to place the ignition in
the OFF mode.
2
Loading ...
Loading ...
Loading ...