Loading ...
Loading ...
Loading ...
#
When giving starting assistance, always
make sure that you only connect bat‐
tery terminals with identical polarity.
#
During starting assistance, you must
observe the described order for con‐
necting and disconnecting the jumper
cables.
#
Do not connect or disconnect the bat‐
tery clamps while the engine is running.
&
WARNING Risk of explosion during
charging process and starting assistance
During the charging process and starting
assistance, the battery may release an explo‐
sive gas mixture.
#
Avoid fire, open flames, creating sparks
and smoking.
#
Make sure that there is sufficient venti‐
lation during the charging process and
during starting assistance.
#
Do not lean over a battery.
&
WARNING Risk of explosion from a fro‐
zen battery
A discharged battery may freeze at tempera‐
tures slightly above or below freezing point.
During starting assistance or battery charg‐
ing, battery gas may be released.
#
Always thaw a frozen battery out first
before charging it or performing start‐
ing assistance.
If the indicator/warning lamps in the instrument
cluster do not light up at low temperatures, it is
very likely that the discharged battery has fro‐
zen. In this case you may neither jump-start the
vehicle nor charge the battery.
The service life of a battery that has been
thawed may be dramatically shortened. The
starting characteristics may be impaired, espe‐
cially at low temperatures.
It is recommended that you have a thawed bat‐
tery checked at a qualified specialist workshop.
All vehicles
*
NOTE Damage caused by numerous or
extended attempts to start the engine
Numerous or extended attempts to start the
engine may damage the catalytic converter
due to non-combusted fuel.
#
Avoid numerous and extended attempts
to start the engine.
Observe the following points during starting
assistance and when charging the battery:
R
Only use undamaged jumper cables/charg‐
ing cables with a sufficient cross-section and
insulated terminal clamps.
R
Non-insulated parts of the terminal clamps
must not come into contact with other metal
parts while the jumper cable/charging cable
is connected to the battery/jump-start con‐
nection point.
R
The jumper cable/charging cable must not
come into contact with any parts which may
move when the engine is running.
Breakdown assistance
375
Loading ...
Loading ...
Loading ...