Loading ...
Loading ...
Loading ...
- 91 -
17. IP TV installation
17.1 Setup
It’s not advised to set the TV in green mode in combination with IPTV because the boot time will be
too slow.
There are some limitations for the multicast stream that can be tuned:
TS stream needs to be compatible with DVB standard
Maximum bit rate 18Mbps
Encapsulation of 7TS packets per IP frame. Each UDP packet must contain exactly 7 data chunks
otherwise the packet is not parsed and it will get lost
Multicast addresses need to be within following range: from 224.0.0.0 to 239.255.255.255
By default the TV will be set to IGMP v2. The switches in the network need to be adapted for
this. If the switches only support v3, then it will be better to change the setting in professional
menu to v3.
Duplex mode must be set to automatic or half-duplex for the 7011 series TV. The 5011 series
TV is able to also support full duplex mode.
17.2 Settings for installing IPTV
To set up an IPTV installation you need to go through the virgin installation as described in the chapter
‘Virgin installation wizard’.
After this you need to apply following settings as described in the chapter ‘Professional settings’:
[Dashboard] [Mode] [Default]
[Date and Time] [Source] [Automatic NTP]
[Advanced] [Professional Mode] [On]
This option always needs to be ON
[Advanced] [Power] [Standby Mode] [Fast]
Setting up this option on Green will reduce the energy consumption in standby, but will
increase the startup time
[Wireless and Networks] [Control TV Over IP] [WebServices]
Note: Below settings are to be able to control the TV’s using CMND
o [Server URL]: Set the URL correct to get the TV’s detected in CMND
o [TVDiscoveryService] [On]
This is the web service through which a web server will detect the presence of TVs in
the IP network using the TV serial number or production code (and other data). This is
achieved by the TV polling the web service server periodically. For the server to
identify the TV uniquely, the TV details or parameters are being passed to the server
o [ProfessionalSettingsService] [On]
This allows changing or requesting the current professional settings parameters. It is
similar to WIxP's professional settings control, except that mechanism used here is
web services, instead of WIxP
o [IPUpgradeService] [On]
This will allow cloning and software update of the TV over IP via CMND
Note: There is no longer need to change your setting for upgrade over IP or RF. Both will
be check automatically.
Loading ...
Loading ...