Loading ...
Loading ...
Loading ...
USER’S GUIDE
7-2
Windows NT 4.0 Printer Setup
1. Log into Windows NT with administrative privileges. From
the Start menu, select Settings and then Printers.
2. Select Add Printer (If you have already installed a Brother
printer driver, double click the printer driver that you wish
to configure and then select Printers/Properties, select the
Ports tab and continue from Step 4 (ignoring steps 9-13)
about installing the correct driver).
3. Select My Computer and then click Next.
4. Select Add a Port.
5. Select Hewlett-Packard Network Port and then click New Port.
6. A list of available print server Ethernet addresses appears in the larger
box under Card Address. Select the address of the desired print server
(the Ethernet address is on the label affixed to the print server, you can
also see it on the printer self test page):
• To do this on a printer that has an LCD panel: take the printer off-
line by pressing the SEL button, press and hold down the SHIFT
button then press the UP arrow button until PRINT CONFIG is
displayed, press the SET button. The printer will then print out a
configuration sheet, the sheet labeled "Print Configuration"
contains all Print Server configuration information. Put the printer
back on-line again by pressing the SEL button.
• For internal Print Servers that are connected to a Brother printer
which do not have an LCD panel, refer to your printer user guide
for instructions on how to print out a configuration page.
• Brother's external interfaces, which connect to the parallel
interface, have a black button recessed into the rear of the unit.
Press this button to print out a configuration sheet.
7. The selected print server address will then appear in the smaller box
under Card Address.
8. Type in any desired name for the port (the name must not be the name
of an existing port or DOS device, such as LPT1) and click OK then on
the Printer Ports screen, click Close.
9. The name you selected in the above step will appear as a checked port
in the list of available ports. Click Next.
10.Select the correct driver click Next.
11.Give a name to the printer. If desired, select the printer as the default.
Select S
hared or Not Shared. If shared, specify the share name and
operating systems that will be printing to it.
Select whether or not you want a test page, and then select Finish.
Loading ...
Loading ...
Loading ...