Loading ...
Loading ...
Loading ...
USER’S GUIDE
A-18
Downloading from a NetWare Server
To download from a NetWare server, first copy the load file e.g.
Firmname.bin into the \login directory on your SYS partition
(SYS:\LOGIN). Using the \login directory will eliminate any potential
file protection problems.
Connect to the print server remote console using BRCONFIG and enter the
following commands in response to Local> prompt.
SET LOAD HOST
fileservername
SET LOAD SOFTWARE SYS:\LOGIN\Firmname.bin
SET LOAD ENABLE
where fileservername is the name of the file server. When you type a
CTRL-D to exit the remote console, the file Firmname.bin will then be
loaded into the print server. The red diagnostic LED will blink during the
load process and will go out when the process is complete.
If the red LED does not go out after about two minutes, check to make sure
that you correctly entered all parameters and that your network connections
are good. Then power the print server off and then on again, enter the SET
LOAD ENABLE command, and exit the remote console to retry the
download.
Loading ...
Loading ...
Loading ...