Loading ...
Loading ...
Loading ...
16Get Started
Essential Video Doorbell Wired
User Manual
• Solid amber. The doorbell isn’t receiving enough power.
You might need to activate bypass mode. For more information, see Use Bypass mode for
the Power Kit on page 73
• You can also consult an electrician or replace your transformer and chime with one that
oers 16-24 VAC, with 10VA minimum.
• Flashing amber. Your Video Doorbell didn’t connect to your WiFi network. During setup,
make sure that your phone and doorbell connect to your 2.4 GHz WiFi network.
• Flashing white. Your Video Doorbell is scanning for a QR code, attempting to connect to
WiFi, or attempting to connect to the Arlo network. If your doorbell LED continues to ash
white for more than a few minutes, change the WiFi settings in your phone to connect to
the same 2.4 GHz WiFi network as the doorbell. Also conrm that your WiFi router has an
Internet connection..
• Alternating amber and white. The operating temperature or voltage is too low. Wait up to
13 minutes for the doorbell to warm up or for its internal battery to charge.
LED aer setup
• Slow breathing pattern white. The doorbell detected motion.
• Solid white. The doorbell was pressed and is calling you or the doorbell is connected to a
call.
• Fading white. The call from the doorbell ended.
Test motion detection
You can use the motion detection test to nd the right motion sensitivity setting for your
doorbell.
1. Open the Arlo app.
2. Tap the gear icon next to the wired Arlo Essential Video Doorbell.
3. Tap Device Utilities > Motion Detection Test.
4. Move in front of the camera.
During this test, the camera LED blinks white when motion is detected.
5. Move the slider to adjust the motion sensitivity level as needed.
6. Edit the ruler to enter the motion sensitivity level that you want to use. See Change motion
sensitivity on page 50.
Loading ...
Loading ...
Loading ...