A2 User Manual - Page 17

Loading ...

“RC

STATUS”

description

Normal: the transmitter and receiver are linked and communicating well.

Disconnect: the A2 Flight Control System is powered on, but the transmitter is powered off.

RC-LOST: RC signal is lost (e.g. the transmitter is turned off after power on) or the receiver

is sending F/S signals (e.g. the aircraft flies out of the range which transmitter is

controllable).

The firmware version and the Assistant Software version should be matched when using the software

to configure the A2 flight control system, otherwise the software will not work. It’s recommended to

keep the firmware version and Assistant Software version up to date to avoid this issues.

1.2.3 Configure the control mode switch

Users should configure the control mode switch in the Assistant software in the following page. Only the control

mode switch has been set correctly, the control mode displayed in the left bottom corner will be the same to the

control mode pointed by the cursor on the channel U.

Configuration steps

Exambles

Step 1.

Power on your Transmitter, map a 3-position

switch on the transmitter to the U channel of

Controller Unit as the control mode switch, of

which two positions are default as Atti. Mode

and GPS Atti. Mode and the third position is

optional, users can set as Atti. Mode or

Manual Mode.

Loading ...