Loading ...
Loading ...
Loading ...
Chapter 80 Networked AV Mode
XGS2220 Series User’s Guide
670
Figure 537 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
80.32 VLAN
This section shows you how to configure 802.1Q tagged and port-based VLANs.
80.32.1 What You Can Do
• Use the VLAN Status screen (Section 80.33 on page 673) to view and search all static VLAN groups.
• Use the VLAN Detail screen (Section 80.33.1 on page 674) to view detailed port settings and status of
the static VLAN group.
• Use the Static VLAN screen (Section 80.34 on page 675) to configure a static VLAN for the Switch.
• Use the VLAN Port Setup screen (Section 80.35 on page 677) to configure the static VLAN (IEEE 802.1Q)
settings on a port.
80.32.2 What You Need to Know
Read this section to know more about VLAN and how to configure the screens.
Table 354 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
LABEL DESCRIPTION
Profile Name Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address Enter the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address Enter the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the Start
Address and End Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...