Loading ...
Loading ...
Loading ...
Chapter 46 Multicast
XGS2220 Series User’s Guide
343
The following table describes the labels in this screen.
46.13.2 MVR Configuration Example
The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN 1. In
addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the News and
Movie channels) from the remote streaming media server, S. Computers A, B and C in VLAN 1 are able
to receive the traffic.
Figure 264 MVR Configuration Example
To configure the MVR settings on the Switch, click the Add/Edit button in the SWITCHING > Multicast >
MVR screen. Create a multicast VLAN and set the receiver and source ports.
Table 162 SWITCHING > Multicast > MVR > Group Setup > Add/Edit
LABEL DESCRIPTION
Multicast VLAN ID Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
Group Name Enter a descriptive name for identification purposes. You can enter up to 32 printable ASCII
characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...