Loading ...
Loading ...
Loading ...
Chapter 13 Neighbor
XGS2220 Series User’s Guide
134
Figure 90 MONITOR > Neighbor > Neighbor (Stacking Mode, example PoE model)
The following table describes the fields in the above screen.
Table 38 MONITOR > Neighbor > Neighbor
LABEL DESCRIPTION
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This shows the port of the Switch, on which the neighboring device is discovered. In
Stacking mode, the first number represents the slot ID and the second is the port number.
Please note that the default stacking ports (the last four ports of your Switch) cannot be
configured. They are reserved for stacking only.
Port Name This shows the port description of the Switch.
PD Health For PoE models.
This shows the status of auto PD recovery on this port.
• Red: The Switch failed to get information from the PD connected to the port using LLDP,
or the connected PD did not respond to the Switch’s ping requests.
• Yellow: The Switch is restarting the connected PD by turning the power off and turning it
on again.
• Green: The Switch successfully discovered the connected PD using LLDP or ping.
• –: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does not
supply power to the connected PD.
Note: The status will NOT be updated instantaneously after enabling or disabling
the Active switch in the Port > Auto PD Recovery screen. It will wait until the
configured Resume Polling Interval (sec) has lapsed.
Link This shows the speed (either 10M for 10 Mbps, 100M for 100 Mbps, 1G for 1 Gbps, 2.5G for
2.5 Gbps, 5G for 5 Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for half).
This field displays Down if the port is not connected to any device.
PoE Draw (W) For PoE models.
This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
System Name This shows the system name of the neighbor device.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a hyper link that you
can click to log into and manage the neighbor device through its Web Configurator.
Loading ...
Loading ...
Loading ...