Loading ...
Loading ...
Loading ...
Chapter 24 IPv6
XGS2220 Series User’s Guide
178
24.4.1 Edit an IPv6 Interface
Use this screen to turn on or off an IPv6 interface you create in the SYSTEM > Interface Setup screen.
Select an entry and click Edit in the SYSTEM > IPv6 > IPv6 Interface Setup screen to display the screen as
shown next.
Figure 125 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
The following table describes the labels in this screen.
24.5 IPv6 Link-Local Address Setup
A link-local address uniquely identifies a device on the local network (the LAN). It is similar to a “private IP
address” in IPv4. You can have the same link-local address on multiple interfaces on a device. A link-
local unicast address has a predefined prefix of fe80::/10.
Use this screen to view and configure the interface’s link-local address and default gateway. Click
SYSTEM > IPv6 > IPv6 Addressing > IPv6 Link-Local Address Setup to display the screen as shown next.
Note: You should first create an IPv6 interface in the SYSTEM > Interface Setup screen.
Select an entry’s check box to select a specific entry.
Edit Click Edit to edit the selected interface.
Table 64 SYSTEM > IPv6 > IPv6 Interface Setup (continued)
LABEL DESCRIPTION
Table 65 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
LABEL DESCRIPTION
Interface Select the IPv6 interface you want to configure.
Active Enable the switch button to enable the interface.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...