Loading ...
Loading ...
Loading ...
Chapter 54 Spanning Tree Protocol
XGS2220 Series User’s Guide
385
54.4 Rapid Spanning Tree Protocol Status
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status
in the navigation panel to display the status screen as shown next. See Section 54.1 on page 378 for
more information on RSTP.
Note: This screen is only available after you activate RSTP on the Switch.
Figure 298 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status: RSTP (Standalone
Mode)
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 190 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup (continued)
LABEL DESCRIPTION
Loading ...
Loading ...
Loading ...