Loading ...
Loading ...
Loading ...
Chapter 36 Link Layer Discovery Protocol (LLDP)
XGS2220 Series User’s Guide
261
36.6 Basic TLV Setting
Use this screen to configure Basic TLV settings. Click PORT > LLDP > LLDP > Basic TLV Setting to display the
screen as shown next.
Figure 190 PORT > LLDP > LLDP > Basic TLV Setting (Standalone Mode)
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable – not allowed
• Tx-Only – transmit only
• Rx-Only – receive only
• Tx-Rx – transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 120 PORT > LLDP > LLDP > LLDP Setup (continued)
LABEL DESCRIPTION
Loading ...
Loading ...
Loading ...