Loading ...
Loading ...
Loading ...
Chapter 57 VLAN
XGS2220 Series User’s Guide
432
Figure 340 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit (Stacking Mode)
The following table describes the labels in this screen.
57.10.1.1 Create an IP-based VLAN Example
This example shows you how to create an IP VLAN which includes ports 1, 4 and 8. Follow these steps
using the screen below:
1 Activate this protocol based VLAN.
2 Type the port number you want to include in this protocol based VLAN. Type 1.
3 Give this protocol-based VLAN a descriptive name. Type IP-VLAN.
4 Select the protocol. Leave the default value IP.
Table 213 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to activate this protocol based VLAN.
Port Type a port number to be included in this protocol based VLAN. In Stacking mode, the first
box field is the slot ID and the second field is the port number.
This port must belong to a static VLAN in order to participate in a protocol based VLAN.
Name Enter up to 32 alphanumeric characters to identify this protocol based VLAN. The string
should not contain [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Ethernet-type Use the drop down list box to select a predefined protocol to be included in this protocol
based VLAN or select Other and type the protocol number in hexadecimal notation. For
example the IP protocol in hexadecimal notation is 0800, and Novell IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not
allowed to be used for protocol based VLANs.
VLAN Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN which you
defined in the SWITCHING > VLAN > VLAN Setup > Static VLAN screen.
Priority Select the priority level that the Switch will assign to frames belonging to this VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...