Loading ...
Loading ...
Loading ...
Chapter 46 Multicast
XGS2220 Series User’s Guide
338
46.11.2 Add MLD Snooping-proxy Filtering Rule
Use this screen to create a multicast addresses range rule of the MLD filtering profile.
Click Add Rule in the SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display this screen.
Figure 258 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
The following table describes the fields in the above screen.
46.12 MVR Configuration
Use this screen to view and create multicast VLANs.
End Address Enter the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 157 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile (continued)
LABEL DESCRIPTION
Table 158 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
LABEL DESCRIPTION
Profile Name Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address Enter the starting multicast IPv6 address for a range of multicast IPv6 addresses that you
want to belong to the MLD filtering profile.
End Address Enter the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Loading ...
Loading ...
Loading ...