Loading ...
Loading ...
Loading ...
RIGOL Chapter 1 Quick Start
1-12 DS8000-R User Guide
3. SFP+ Interface
SFP (Small Form-factor Pluggable) module electrical interface. It is an
optical transceiver and supports hot plugging. Through this interface, the
oscilloscope can support 10 Gbit/s data transmission rate.
4. HDMI Video Output
Through this interface, you can connect the instrument to an external
display (e.g. monitor or projector) equipped with the HDMI interface to
better observe the waveform display clearly.
5. USB DEVICE Interface
You can connect the instrument to the PC via this interface. Then you can
use the PC software Ultra Scope to send the SCPI commands, or use the
user-defined programming to control the instrument.
6. 10 M In/Out
Indicates the reference clock. It can provide accurate sample clock signal
for the oscilloscope, and can be used to synchronize the clock of two or
multiple oscilloscopes.
7. EXT
Inputs the external signal via the external input terminal.
8. GEN
Outputs the built-in signal output from the function/arbitrary waveform
generator via this GEN connector. This function is only available for the
model installed with the DS8000-R-AWG option.
9. Trigger Out and Pass/Fail
âš« TRIG OUT
The oscilloscope can output a signal that can reflect the current
capture rate of the oscilloscope at each trigger via this interface.
Connect the signal to a waveform display device and measure the
frequency of the signal. The measurement result is the same as the
current capture rate.
âš« Pass/Fail
The instrument can output a pulse from the [TRIG OUT] connector
when a pass/failed event is detected during the pass/fail test.
10. Fuse
If you need to replace the fuse, use only the specified fuse. For details, refer
to descriptions in "To Replace the Fuse".
11. AC Power Cord Connector
Indicates the input terminal where AC power source is connected. The
power supply requirements of the instrument are: 100 V~240 V; 45
Loading ...
Loading ...
Loading ...