Loading ...
Loading ...
Loading ...
Chapter 11 Protocol Decoding RIGOL
DS8000-R User Guide 11-31
display formats of the bus data are "Hex", "Dec", "Bin", and "ASCII".
âš« Adjust the vertical position of the bus
Click Position, and then place the mouse cursor over the menu to scroll
with the mouse or drag the decode label at the left side of the screen to
adjust the vertical display position of the bus.
âš« Set the label display
Click Label continuously to enable or disable the label display of the
FlexRay decoding bus. When enabled, the bus label "Flexray" will be
displayed at the upper-left side of the bus (when the bus display is
enabled).
âš« Event table
Click Event Table to enter the event table setting menu. The event table
displays the detailed decoding information in time order in the form of a
table, so as to better observe the long decoded data. The decoding
information includes the decoded data, the corresponding line number, time,
frame ID, and Payload Length (PL).
➢ Open or close the event table: Click Event Table continuously to
enable or disable the event table. When you enable the event table,
the following figure is displayed, as shown in Figure 11-13. You can
also click on the icon at the upper-right corner of the table to close
the event table. Besides, when the operating status is "STOP", you can
select a specified line and view the corresponding decoding
information.
Figure 11-13 FlexRay Decoding Event Table
Note:
âš« When you adjust the horizontal time base, the waveform displayed
Line Number Time Frame ID PL Header CRC CYC Decoded Data Frame CRC
Event Table
FlexRay Bus
Loading ...
Loading ...
Loading ...