FLUKE 710 mA Loop Valve Tester

User Manual for the Fluke 710 mA Loop Valve Tester - Page 42

For 710.

PDF File Manual, 48 pages, Read Online | Download pdf file

710 photo
Loading ...
Loading ...
Loading ...
Precision Loop Calibrator
Valve Tests (710)
37
Step Test
In this test the mA signal is changed in steps and compared to the
position variable (QV).
To set up the step size for the test from 0.1 mA to 4 mA, rotate the
selection knob to change the mA value.
Figure 55. Step Test
To run the test:
1. Push to start the test.
Good test result: the position variable is as expected.
Marginal test result: the position variable value is found to
be close to the test tolerance.
Bad test result: the position variable deviation values vary
greater than the tolerance.
2. Select Save to save the test results and upload later to the
ValveTrack software.
Or, select Discard if you do not want to save the test result.
Bump/Partial Test
The Bump/Partial Test is a test of the valve over a smaller portion
of the stroke, or bump the mA value, to find if the valve moves as
expected. This is also done with a Manual Test of the position or
other values.
To set up:
1. Set the start and stop stroke values in % of travel.
Figure 56. Bump/Partial Test
To run the test:
1. Push to start the test.
Good test result: the position variable is as expected.
Marginal test result: the position variable value is found to
be close to the test tolerance.
Bad test result: the position variable deviation values vary
greater than the tolerance.
2. Select Save to save the test results and upload later to the
ValveTrack software.
Or, select Discard if you do not want to save the test result.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...