Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/36742184-ds-k3bc430lx/bg44.png)
5. Set the baud rate, data bit, the stop bit, parity type, and
connecon mode in the drop-down list.
6. Click Save.
●
The congured parameters will be applied to the device
automacally.
●
When you change the connecon mode, the device will
reboot automacally.
Set Wiegand Parameters
You can set the access control device's Wiegand channel and the
communicaon mode. Aer seng the Wiegand parameters, the
device can connect to Wiegand card reader via Wiegand
communicaon.
Before You Start
Add access control device to the client, and make sure the device
supports Wiegand.
Steps
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3. Select an access control device in the device list and click
Wiegand to enter the Wiegand
Sengs page.
4. Set the switch to on to enable the Wiegand funcon for the
device.
5. Select the Wiegand channel No. and the communicaon mode
from the drop-down list.
Note
If you set Communicaon Direcon as Sending, you are
required to set the Wiegand Mode as Wiegand 26 or Wiegand
34.
6. Click Save.
●
The congured parameters will be applied to the device
automacally.
●
Aer changing the communicaon direcon, the device will
reboot
automacally.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of
authencaon.
Steps
Note
The funcon should be supported by the access control device
and the card reader.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3. Select an access control device in the device list and click M1
Card
Encrypon to enter the M1 Card Encrypon page.
4. Set the switch to on to enable the M1 card encrypon
funcon.
5. Set the sector ID.
55
Loading ...
Loading ...
Loading ...