Loading ...
Loading ...
Loading ...
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Funcon → Device
Parameters .
Note
If you can not nd Device Parameter in the Advanced Funcon
list, hover the cursor on the Advanced Funcon, and then Click
to select the Device Parameter to be displayed.
2. Select an access device to show its parameters on the right
page.
3. Turn the switch to ON to enable the corresponding funcons.
Note
●
The displayed parameters may vary for dierent access
control devices.
●
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Enable NFC
If enable the funcon, the device can recognize the NFC
card. You can present NFC card on the device.
Enable M1 Card
If enable the funcon, the device can recognize the M1 card.
You can present M1 card on the device.
Enable EM Card
If enable the funcon, the device can recognize the EM card.
You can present EM card on the device.
Enable CPU Card
Reserved. If enable the
funcon, the device can recognize
the CPU card. You can present CPU card on the device.
Enable ID Card
Reserved. If enable the funcon, the device can recognize
the ID card. You can present ID card on the device.
4. Click OK.
5.
Oponal: Click Copy to, and then select the access control
device(s) to copy the parameters in the page to the selected
device(s).
Congure Parameters for Door/Elevator
Aer adding the access control device, you can congure its
access point (door or
oor) parameters.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced
Funcon → Device
Parameter .
2. Select an access control device on the le panel, and then click
to show the doors or oors of the selected device.
3. Select a door or oor to show its parameters on the right page.
4. Edit the door or oor parameters.
51
Loading ...
Loading ...
Loading ...