Loading ...
Loading ...
Loading ...
Figure 7-10 Serial Port Sengs
2. Set the No., Baud Rate, Data Bit, Stop Bit and Parity.
3. Set the Peripheral Type as Card Reader, Card Receiver, QR
Code Scanner or Disable.
4. Set the Peripheral Posion as Entrance or Exit.
5. You can view the serial port type, external device model and
peripheral
soware version.
6. Click Save.
Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
Note
Some device models do not support this funcon. Refer to the
actual products when conguraon.
1. Click Conguraon → Access Control → Wiegand Sengs .
2. Select Entrance or Exit.
3. Enable Wiegand funcon.
4. The wiegand transmission direcon is set Input by default.
Note
Input: the device can connect a Wiegand card reader.
5. Select Wiegand Mode.
6. Click Save to save the sengs.
Note
If you change the peripheral, and aer you save the device
parameters, the device will reboot automacally.
Set Terminal Parameters
Set the working mode and remote vericaon.
Steps
1. Click Conguraon → Access Control → Terminal Parameters
to enter the page.
29
Loading ...
Loading ...
Loading ...